A novel multi-objective optimization method: Input values effect on responses (IVER)

In this study, a novel multi-objective optimization method based on the best effect of unique input (independent variable) values on responses (dependent variables) was proposed. The proposed method was compared with optimization using Derringer & Suich function that is still the most used. The comparison was made using the response values measured in real experiments and available in the literature. The advantages of the proposed method such as not needing the polynomial model aiming to predict the response values, no parameter selection problem, being able to offer optimum range instead of single optimum value, being suitable for use with existing experimental designs and being simple and interpretable were demonstrated as a result of comparison. It was also suggested how the proposed method will be effective according to experimental designs, and application for the users' application was presented.     

沁水盆地赵庄矿3号煤层地面煤层气抽采低产原因分析

在对沁水盆地赵庄矿煤层气开发地质、煤层气生产井资料深入研究的基础上，分析、总结了区内煤层气直井低产原因，并据此提出了区内地面抽采后续开发方向。研究认为:3号煤层气含量偏低、含气饱和度低、临储比低，致使排采阶段气含量可降幅度低，是其低产的宏观表征；3号煤储层不匹配孔级，较差连通性，即微、小孔为主，中孔次之，大孔不发育，微裂隙连通性差，致使扩散缓慢、影响储层改造和抽采效果，是其低产的微观表征；3号煤层远高于顶底板塑性及相近的水平应力，进一步造成改造缝长受限，泄流面积不足。因此，建议区内后续地面抽采方式应以增大泄流面积开发方式为主。     

洋葱蛋白及多肽的制备及其体外抗氧化活性评价

对洋葱蛋白、4种不同水解度的粗洋葱多肽、4种分子量范围的纯化多肽组分的水解度、分子量、氨基酸组成、DPPH·清除能力进行了研究。结果表明,洋葱蛋白酶解后分子量大幅降低,必需氨基酸组分和支链氨基酸组分均有所提高,DPPH·清除能力大幅提高,且与水解度成正比;在4种水解度的粗洋葱多肽的纯化组分中,P-III(分子量为1~5kDa)的DPPH·清除能力均为最强,这归功于其合适的分子量分布。该研究为洋葱的高值化利用提供了理论依据。     

卡尔费休法测定液态氯乙烯中水含量的研究

采用卡尔费休法测定了液态氯乙烯单体中的水含量。试验确定了采样工具、样品的预处理方式及选用溶剂的最优方案,并进行了精密度与准确度的验证。结果表明卡尔费休法测定液态氯乙烯单体中的水含量准确、快速,可以用来准确、及时地指导生产。     

咖啡渣活性炭的制备、表征及其对Cr(Ⅵ)的吸附机制研究

以碘吸附值为评价指标，活化时间、活化温度和浸渍比为影响因素，采用响应面法试验设计对磷酸活化法制备咖啡渣活性炭的工艺条件进行优化，并通过静态吸附试验研究了不同吸附时间、溶液pH值和吸附温度条件下，活性炭对水溶液中Cr（Ⅵ）吸附性能的影响，最后利用Langmuir、Freundlich吸附等温方程、准一级动力学方程、准二级动力学方程和颗粒内部扩散方程进行拟合。试验结果表明，制备咖啡渣活性炭的最佳工艺条件为活化时间1 h、活化温度498℃、浸渍比1.72；在此条件下活性炭得率为30.4%，碘吸附值为（799±16）mg/g，比表面积为1 006 m²/g，孔容为0.779 cm³/g、微孔孔容为0.051 cm³/g、平均孔径为3.088 nm。较低pH值和较高温度能够促进活性炭对Cr（Ⅵ）的吸附；Langmuir等温方程能够更好地描述活性炭对Cr（Ⅵ）的吸附效果；活性炭对Cr（Ⅵ）的吸附分3个阶段：快速吸附阶段、慢速吸附阶段和吸附平衡阶段，10 min内可完成吸附总量的79%，360 min内达到吸附平衡，该吸附过程符合准二级吸附动力学方程。分析表明咖啡渣活性炭对Cr（Ⅵ）的吸附主要为单分子层的化学吸附。     

阿尔泰南缘北塔山组火山岩锆石U-Pb定年及地质意义

新疆阿尔泰南缘北塔山组火山岩较为发育。本文对新疆阿尔泰南缘默色克奥依一带北塔山组火山岩进行地球化学分析和年代学研究。研究表明：U-Pb锆石年龄为（384.3±4.0Ma）Ma，为中泥盆世；该组火山岩属于钾质钙碱性系列，全碱（Na2O+K2O=2.07%-6.49%）和YiO2（0.24%-0.64%）含量较低，K2O含量（1.11%-4.04%）变化较大，稀土元素含量（∑REE）较低。稀土元素显示其轻稀土富集且分馏不明显；δEu值均大于1，为Eu富集型；δCe值均小于1，为Ce亏损型。该组火山岩微量元素P明显富集，K、Rb、Ba等大离子亲石元素（LILE）略富集，亏损Ta、Zr、Hf、Ti等高场强元素（HISF）。结合前人研究，本文认为默色克奥依一带北塔山组火山岩形成于岛弧及与俯冲过程有关的活动大陆边缘造山带环境，为泥盆纪古大洋俯冲消减过程中，俯冲板片脱水产生的流体交代上覆地幔楔部分熔融的产物。     

基于化学监督的超(超)临界机组关键控制节能指标分析及建议

针对超(超)临界机组参数提高、材质升级,化学技术监督中的监督指标对机组经济性和可靠性影响较大的问题,本文通过机组典型案例分析、技术监督报告、现场实测等,对目前化学监督中影响较大的、关键的技术指标进行了系统性的分析研究。研究结果找出了6项化学监督中超(超)临界机组关键的、影响较大的控制监督指标,且提出了指标控制值和控制方法。这项系统性研究分析方法对指导超(超)临界机组化学监督具有重要的借鉴作用,以控制超(超)临界机组因参数提高和材质升级带来的新问题和新挑战。     

Large eddy simulation of flow over square cylinder arrays in an octagonal configuration at subcritical Reynolds numbers

In this study, fluid flow over an array of eight, 0.029 m × 0.029 m, square cross‐section cylinders in an octagonal configuration is studied numerically. The mean force coefficients (drag and lift) and the vortex formation characteristics of the array are calculated numerically by utilizing a three‐dimensional large eddy simulation mathematical model for turbulence. The numerical simulation is performed with commercial software ANSYS Fluent 19R1. To investigate the parametric influences, three spacings between the cylinders (0.07, 0.14, and 0.2 m), two array attack angles (0° and 15°), and two Reynolds numbers (4060 and 45 800) are considered. The results comprise flow patterns and force coefficients' variations with Reynolds numbers. The lift force of the downstream cylinder reaches its maximum at α = 15°, and the drag force of the upstream cylinders finds its peak at α = 0°. It is observed through velocity and viscosity contour plots that vortex formation length near the cylinder increases at higher Reynolds number. Velocity vector plots are also presented to show fluid flow behavior near the cylinder. Furthermore, the predicted mean forces on the cylinders are slightly different for different Reynolds numbers, spacings, and angles of attack.     

牵引车载荷对NOx排放和排温影响的试验研究

在五轴动力总成试验台架上对牵引车在不同载荷下进行同一路谱的排放试验,研究牵引车在不同载荷下NOx排放和排温的变化,得到载荷与排放物和选择性催化还原(selective catalytic reduction,SCR)上游排温的变化关系。结果表明:载荷为标定载荷的60%以下时,NOx比排放值与载荷基本呈线性相关;载荷超过标定载荷的75%时,NOx比排放值与载荷呈二次项相关;载荷在为标定载荷的23%以上时,NOx比排放值与SCR上游排温基本呈线性相关。利用该试验结论可以通过只进行单一载荷排放试验,判断车辆在其他载荷下的排放水平是否满足国家标准要求,并可通过载荷对排温的影响规律预判排放水平。     

Studies on spinel cobaltites,MCo2O4 (M = Mn,Zn, Fe,Ni and Co) and their functional properties

Optimization of electrodes for charge storage with appropriate processing conditions places significant challenges in the developments for high performance charge storage devices. In this article, metal cobaltite spinels of formula MCo₂O₄ (where M = Mn, Zn, Fe, Ni and Co) are synthesized by oxalate decomposition method followed by calcination at three typical temperatures, viz. 350, 550, and 750 °C and examined their performance variation when used as anodes in lithium ion batteries. Phase and structure of the materials are studied by powder x-ray diffraction (XRD) technique. Single phase MnCo2O4,ZnCo2O4 and Co3O4 are obtained for all different temperatures 350 °C, 550 °C and 750 °C; whereas FeCo₂O₄ and NiCo₂O₄ contained their constituent binary phases even after repeated calcination. Morphologies of the materials are studied via scanning electron microscopy (SEM): needle-shaped particles of MnCo₂O₄ and ZnCo₂O₄, submicron sized particles of FeCo₂O₄ and agglomerated submicron particle of NiCo₂O₄ are observed. Galvanostatic cycling has been conducted in the voltage range 0.005–3.0 V vs. Li at a current density of 60 mA g^?1 up to 50 cycles to study their Li storage capabilities. Highest observed charge capacities are: MnCo₂O₄ – 365 mA h g^?1 (750 °C); ZnCo₂O₄ – 516 mA h g^?1 (550 °C); FeCo₂O₄ – 480 mA h g^?1 (550 °C); NiCo₂O₄ – 384 mA h g^?1 (750 °C); and Co₃O₄ – 675 mA h g^?1 (350 °C). The Co₃O₄ showed the highest reversible capacity of 675 mA h g^?1; the NiO present in NiCo₂O₄ acts as a buffer layer that results in improved cycling stability; the ZnCo₂O₄ with long needle-like shows good cycling stability.